Access door for water chambers, ready for installation, single door, double skinned
Completely made from 1.4404 stainless steel (AISI 316 L), with double rubber seal. The door and frame closing flush, the door opening to the outside (in escape direction).
Door leaf, skin: 1 mm, 55 mm thick, with injected CFCs-free polyurethane hard foam insulation, longitudinally ground surface finish, door seal certified to KTW and DVGW W270 standards. Fastened to the frame with stable maintenance-free hinge plates. Mortise dead lock completely made from stainless steel according to DIN 18251, class 3, provided for a customer-provided profile half cylinder, lockable only from the dry side. Stainless steel door handle set with button outside and handle inside.
Frame, three-sided, fabricated from special section, with inserted frame seal certified to KTW and DVGW W270 standards, selectable sill closure, including fixing material.
Frame and door shielded arc-welded and acid bath cleaned before washing, drying and surface passivation.
Options
Frame:
- Z-frame
- Block frame
Mounting:
- Embedded
- Bolted with dowelling clips
- Bolted through the frame (not to affect the finished wall)
Door opening options:
- Hinges on left
- Hinges on right
Sill closure:
- With step flashing
- Circumferential block frame on four sides
Other Options:
- Upper door closer, lockable in position (mounted on the dry side)
- One-part or two-part door arrestor
- Electronic monitoring options (alarm system in door surface, magnetic contact, lock-bolt contact, block lock)
- Potential equalisation on frame (dry side)
Downloads
