Energy-Efficient Biological Treatment

Biological wastewater treatment consumes 50 – 80 % of an entire plant’s power supply. Energy efficiency thus depends predominantly on its design.

  • Simultaneous aerobic stabilization or extended aeration has a high power consumption of 25 – 30 kWh/(PE•a).
  • Activated sludge systems designed for N removal after primary clarifiers consume 15 – 20 kWh/(PE•a) and permit power generation from digester gas.
  • Activated sludge systems designed only for carbon (BOD) removal consume around 10 kWh/(PE•a). Nutrient removal is not always required, particularly where effluents are reused for irrigation (See also Huber ReUse Solutions).
  • Nitrifying trickling filters consume 7 – 10 kWh/(PE•a) and nitrifying rotating contactors only 2 - 4 kWh/(PE•a).
  • Multi-stage biological treatment is often more energy-efficiency than single-stage treatment.

The following recommendations apply for activated sludge treatment:

  • Most power is consumed for aeration and tank mixing.
  • The aerobic sludge age must be sufficient for the selected process, but should not be too long either. Oxic, anoxic and anaerobic tank volumes should be variable; e.g. less oxic volume is needed during summer.
  • Fine bubble diffusers are more energy-efficient than coarse bubble diffusers or mechanical aerators. Optimum bubble diameter is around 2 mm.
  • Even arrangement of air diffusers on a tank’s bottom improves oxygen transfer and reduces power consumption.
  • Energy-efficiency of fine bubble aeration has an optimum at 4 - 6 m immersion depth
  • Turbo-blowers consume about 10 % less energy than roots blower.
  • Smart control of oxygen concentration, redox-potential or ammonium and nitrate concentration saves power.
  • Efficient propellers for non-aerated tank mixing consume 1.5 – 3.0 W/m³ tank volume, or 1.5 – 3.0 kWh/(PE•a).
  • Internal recirculation should be controlled. Variable flow propeller pumps consume around  0.5 kWh/(PE•a).
  • Sludge return flow should be controlled. Variable flow centrifugal pumps consume about 0.5 kWh/(PE•a).
  • Secondary clarifier scrapers and surplus sludge pumps consume around 0.15 kWh/(PE•a).

See also Membrane Bio-Reactors.

https://www.huber.de//solutions/energy-efficiency/wastewater-collection-and-treatment/biological-treatment.html